Arterra Fauna Paver

Arterra Fauna is a brown porcelain paver offered in 2 sizes, from 13 by 24 up to 8 by 47 inches. Fired dense enough to absorb less than 0.5 percent water under ASTM C373, it handles wet areas, heavy traffic, and temperature swings without sealing. Its thicker body is made for outdoor living areas, from pool decks to garden paths.

Deep browns pair with cream, rust, and olive for a grounded scheme, or with pale gray for quiet contrast.

Porcelain tile is a dense, low-porosity ceramic fired from refined clay at temperatures above 1,200°C (2,200°F), which vitrifies the body into a hard, water-resistant surface. Certified porcelain absorbs less than 0.5 percent of its weight in water under the ASTM C373 test, and that low absorption is what lets it handle wet rooms, freeze-thaw climates, and heavy foot traffic without cracking or staining. Stone-look and wood-look porcelain takes its pattern from high-resolution digital printing applied before firing, so the design runs crisp and consistent across every piece while the body underneath stays far tougher than the natural surface it imitates. Unlike natural stone, porcelain needs no sealing and does not etch under acidic cleaners, which makes it a low-maintenance choice for kitchens, bathrooms, and busy floors.

Porcelain tile should be set with a polymer-modified thin-set mortar rated for porcelain over a flat, clean, dry substrate. Rectified porcelain, with machine-squared edges, allows tight grout joints down to about one-eighth inch, while pressed-edge tile needs a slightly wider joint to absorb minor size variation. Porcelain requires no sealing, because its body is already vitrified and non-absorbent; only cement grout benefits from a sealer. Clean it with water or a pH-neutral cleaner, and unlike natural stone it tolerates most household cleaners without etching. For large-format pieces, use a tile-leveling system and back-butter each tile for full mortar coverage, which prevents lippage across the wider surface.